model:
ACC-VNTH1
Wireless Temperature/Humidity Sensor
Installation Instructions
OVERVIEW
This wireless temperature sensor may be used as a room remote temperature sensor or an outdoor temperature sensor.
When used as an outdoor sensor it must be kept out of direct rain and sunlight.
Venstar thermostats vary by model in the way they can use remote sensors. This includes averaging, control to, or monitoring features.
Please consult the Owner’s Manual of the thermostat that you are going to pair this sensor with to understand its capabilities.
This sensor is compatible with Venstar VenNet thermostats that contain the latest firmware.
If you are wanting to pair this sensor to a thermostat other than what is depicted in these instructions,
please scan the QR code or look on venstar.com/support/accessories/vennet-temp-hum-sensor-support/
for pairing instructions and a list all compatible thermostats.
fig. 1
SPECIFICATIONS
Temperature Measurement Range:
-40°F - 130°F
Humidity Measurement Range:
0 – 100% RH
Temperature Sample rate
Once a minute
Expected Battery Life - Type CR2450
• Remote Sensor sample rate of 1per minute: > 1 year
TO PAIR THIS VenNet SENSOR TO A THERMOSTAT:
1. Make sure a fully charged CR2450 battery is installed in the
sensor as shown in Fig. 1.
PULL BACK TO
REMOVE BATTERY
PRY HERE WITH
FINGER TO REMOVE
BATTERY
How to remove
the sensor cover
1.
REMOVE THIS TAB.
2.
HOLD SENSOR NEAR
STAT, PRESS BUTTON
FOR 2 SECONDS.
3.
FOLLOW THE
INSTRUCTIONS
ON STAT.
TO PAIR:
Before initial use pull this
mylar tab out from under
the battery
Note: Extended extreme temperatures may have a negative impact on range and battery life.
Use phone camera
for more info
