NOTE:
The inner panel (inner filler bar) is the long, slender bar
between the power supply and the trays (arrow shown). the
inner filler bar does not apply to the
AP 7000
20
CURVE™ Door AP 113, AP 123, AP 7000
INSTALL THE CURVE DOOR
REMO
VE OEM DOOR
INS
TALL DOOR
HARNESSES
INS
TALL BUCKET
FINAL INS
TALL
ADJUS
T DOOR
Then, for
AP 113
, and
AP 123
, tighten top
screw of ballast filler panel (see arrow).
Next, attach the door stop arm to inside stud
closest to the inner door frame (see arrow) and
turn 1-1/2 turns from tight.
Next, for the
AP 113
, and
AP 123
, align
Inner Panel
(VED3597)
slotted key ways with existing holes. Then, reinstall
screws removed from “Removing OEM Door”,
, allowing ample space to hang inner panel on slotted key
ways.
After hanging the inner panel, insert Phillips screwdriver
through the inner panel holes as shown to tighten all
screws in each key way.
INSTALLATION GUIDE
10
11
Ballast Filler
Panel
Trays
THIS SECTION IS COMPLETE,
MOVE ON TO NEXT SECTION
Power Supply
Cover
8
Closest Stud
Inner Door Frame
9
