VB26 Quick start guide
Video server quick
start.docx
By default, a VB26 comes configured in the following way.
VBOX address: 192.168.1.100
Preset camera address: 192.168.1.101
Changing your network adaptor
To access the unit attach the ethernet cable to your pc/laptop and into the ethernet adaptor of the
VBOX. When plugging in the connector to the VBOX make sure that the cables for the ethernet socket
are on the right if you have the VBOX socket facing you and the SIM/SD card slots on the right side
On the taskbar at the right on your computer, you should see one of these 2 icons
right click on it and then select open Network & Internet settings then click on:
Right click on Ethernet
and select properties
Highlight
and click the properties button
On this next screen, we need to change your pc/laptop’s IP address so it can connect to the VBOX
Click use the following IP address and put in 192.168.1.10 and click on the subnet mask below and it
will populate for you, leave the others blank and click OK (remember once you have finished
configuring the VBOX to change this window back to how it was before)
Accessing the unit
Open up a webpage and type in 192.168.1.100:8080 and press enter you will be greeted by a
Password box this is blank so just press ‘Enter’
to access the configuration page. There will be one
camera and encoder already configured. The camera is set with the IP of 192.168.1.101 and a
username of admin and a password of 42!Password. With regards to the profile