Vemco HR2, User Manual

Page: 20 / 212

1.7 Hardware Tabs
Fathom
hardware tabs provide access to communication ports and receivers (when a receiver is
connected and identified).
Figure 1-6: Device Scanner and Receiver hardware tabs
1.7.1 The Device Scanner Tab
The Device Scanner tab is the initial, or start-up tab. When you connect a receiver, the software
attempts to identify it. For more information, see " Device Scanner Tab", on page 23 .
l
If a receiver is identified
, a receiver icon is displayed; double-clicking this icon will open a
hardware communication tab for that receiver (a Receiver tab).
l
If Fathom is unable to identify the connected receiver
, you must perform a manual connection
to open a communication tab for that receiver. For more information, see "If no receiver is
detected", on page 25
1.7.2 The Receiver Tab (s)
A Receiver tab is used, and only available, when Fathom is connected and communicating with an HR2
receiver. For more information, see " Receiver Tab", on page 28 .
NOTE:
Each connected receiver gets its own tab.
11
1.7 Hardware Tabs