16
Figure 15.
Temperature Limit
➢
Enter in the menu, rotate speed control knob (C) till the delta temperature desired value. Click to confirm.
➢
Rotate the knob (C) to set the interval time in which the delta temperature has to be considered. Click to
confirm.
➢
Rotate the knob (C) to set the percentage of speed reduction desired if the selected delta temperature is
detected in the set interval time. Click to confirm.
➢
Speed reduction can be set by 10% steps.
Acceleration
➢
It allows to choose among 3 different acceleration types when the instrument starts to stir or when a higher
set point value is set.
➢
Enter in the menu, select Slow, Medium, or Fast depending on the customer application.
➢
Click speed control knob (C) to confirm.
Vibration
sensor
➢
It allows to set a vibration sensitivity level.
➢
Enter in the menu, rotate speed control knob (C) to select OFF, Low, Medium or High. Click to confirm.
➢
When vibration sensor level is set different than OFF,
appears on the blue upper bar (3).
7.5
Set-up
Motor Type
➢
It allows to set the type of the motor connected to the instrument
➢
Enter in the menu, rotate speed control knob (C) to select the motor connected physically. Click to confirm.
➢
Motor 5:1
– 500 rpm:
4 poles, 24V, 1/4HP, Max 8.3A, Max rpm 500
➢
Motor 6:1
– 417 rpm:
4 poles, 24V, 1/11HP, Max 4.4A, Max rpm 417
➢
Motor 10:1
– 250 rpm:
4 poles, 24V, 1/4HP, Max 8.3A, Max rpm 250
Start Mode
➢
It allows to set instrument
’s restart mode in case of blackout or power loss.
➢
Enter in the menu, rotate speed control knob (C) to select Stop or Run. Click to confirm.
➢
Stop
: when the instrument is switched on,
it’s requested a click of the control knob to start stirring.
➢
Run:
when the instrument is switched on, it restarts to work with the last set point set.
➢
If Stop is selected, A appears on the blue upper bar (2).
➢
If Run is selected, B appears on the blue upper bar (2).
Wi-Fi Set-up
➢
It allows to switch on wi-fi module for IoT transmission.
➢
Enter in the menu, rotate speed control knob (C) to select ON or OFF. Click to confirm.
➢
When wi-fi is ON,
appears on the blue upper bar (1).
Wi-Fi
Information
➢
It describes all wi-fi information (MAC address, Power of signal, wi-fi name).
Display
➢
It allows for brightness to be set or if torque and temperature should be displayed on the main screen.
➢
Enter in the menu and scroll with speed control knob (C). Click to enter in submenus.
