5
.
w w w . v e l o d y n e . c o m
VMS User’s Manual
Figure 1. Installation Using LFE Line-Level Inputs
Note:
If not using an external crossover, you should use the built-in crossover for optimal
performance. When using a single channel input (such as a surround sound processor’s
subwoofer out or LFE), the auto on/off circuit sensitivity will be affected. When one input
channel is used instead of two, the unit will see lower signal levels present at the inputs. This
may cause the unit to turn off when listening at low volume levels. If this occurs, simply use a
“Y” adapter (available from most dealers) to allow your processor’s single sub line to be fed into
both L&R inputs. This will make the unit turn on at lower signal levels.
