LEDA210NW
V. 02
–
15/02/2016
5
©Velleman nv
6.
Connection
Refer to the illustrations on page 2 of this manual.
1.
Loosen the 4 screws of the connection compartment using an
appropriate screwdriver.
2.
According to your installation spot, punch one of the installation holes.
3.
Install the rubber seal in the freed installation hole.
4.
Slide the power cable through the rubber seal and connect to the
screw terminal.
5.
Close the connection compartment and secure with the screws.
6.
Install the bulkhead lamp.
7.
Cleaning and Maintenance
This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
All screws should be tight and free of corrosion.
The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not be
deformed, modified or tampered with; e.g. do not drill extra holes in
mounting supports, do not change the location of the connections…
The electric power supply cables must not show any damage. Have a
qualified technician maintain the device.
If the protective glass is damaged, disconnect the lamp immediately
from the mains. Have it repaired immediately by a qualified technician.
Do not use the lamp with a cracked or broken protective glass.
Wipe the device regularly with a moist, lint-free cloth. Do not use
alcohol or solvents.
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.
8.
Technical Specifications
electrical data
power LED module
21 x 2835 LEDs
total nominal power
5.5 W
nominal voltage driver
230 V~
power factor
>0.5
energy consumption (kWh/1000 h)
6
