VTUSD2_v3
VELLEMAN
1
VTUSD2 – ULTRASONIC DISTANCE METER WITH LASER
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the
VTUSD2
! Please read the manual carefully before bringing this device into service.
2.
General Safety Rules
3. Installing the Battery
Use a 9V alkaline battery for optimum performance (not included). Slide the cover of the battery compartment in the
direction of the arrow. Make sure the black ribbon is under the battery when you insert it and respect the polarity
indications on the inside of the battery compartment. Replace the cover.
The battery needs to be replaced when the device no longer functions properly and the message “
LOW BAT
” is
displayed on the LCD. We advise you to remove the battery in case of prolonged inactivity since a leaking battery
can destroy electronic parts.
4. Stabilising the Distance Measurer
The device is sensitive to changes in temperature and humidity. Wait ± 15 minutes and let the device reach room
temperature prior to use.
5. Activating/Deactivating the Device
Place the
LD/NORMAL/OFF
slide switch on the side of the device in the
LD
or
NORMAL
position to turn on the
device. The laser will always work in the LD or NORMAL position. The display will deactivate automatically if no
measurements are performed for 4 minutes. The laser on the other hand stays activated. Put the slide switch in the
OFF
position to turn the device off completely.
Note that all previous measurements are erased from the memory when the device is deactivated.
6. Measurements
a. Place the
LD/NORMAL/OFF
switch in the
NORMAL
position when measuring a distance < 35ft (10.67m). Place
the switch in the
LD
(Long Distance) position when measuring a distance > 35ft.
b. Point the laser beam at the measuring object.
c. Press the
FEET/METER
button repeatedly until
FEET
or
METER
is displayed, depending on the desired unit of
measurement.
d. Place the bottom of the device against the wall about halfway between the floor and ceiling. Make sure your
hands are not blocking the front of the device.
e. Press the
MEASURE/ON
button. The device beeps and the distance from the device to the target object is
displayed on the LCD.
CAUTION
– Laser Radiation – Do Not Stare Into Beam – Class 2 Laser
Wavelength: 630-680nm – Max. Output Power: < 1mW – EN60825 – 1:1994 + A1 + A2
