VL2500HUF
1
VELLEMAN
VL2500HUF – ULTRAFAST Ni-MH C 4 AA BATTERIES
1. Introduction & Features
At the end of its life cycle, dispose of this product in accordance with local and national disposal regulations.
Thank you for buying the
VL2500HUF
! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
•
Recharges 1-4 AAA and AA Ni-MH batteries at a time
•
Supplied with DC (12V) and AC adapter (100-240Vac, 50/60Hz, internationally compatible)
•
Microprocessor-controlled with –
δ
V detection and thermal and timer protection
•
Automatic charging current selection according to battery size (AA or AAA)
•
LED indication for fast charge (red), trickle charge (green) and bad cell detection (red and flashing)
•
4 Ni-MH AA batteries (2500mAh) are included
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or problems.
•
All modifications of the device are forbidden for safety reasons. Damage caused by such modifications is not
covered by the warranty.
•
Keep the device away from children and unauthorised users.
•
Disconnect the device from the mains to clean it or when it is not in use.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device is protected against extreme heat, dust and moisture.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
3. Operation
•
Insert 1 to 4 AA or AAA rechargeable Ni-MH batteries into the battery compartments. Mind the polarity.
•
Connect the adapter to the DC input jack of the charger and plug it into a wall outlet (AC adapter) or the car lighter
socket (DC adapter). Either way the power supplied to the charger is 12Vdc/3.3A. Using an adapter that does not
provide these specific values may damage the charger, the batteries and the adapter itself.
•
The LEDs next to the batteries will turn red to indicate the batteries are being charged (fast charge). When the
LED turns green, the charger switches from fast charge to trickle charge. The batteries are now ready to be used.
•
If a red LED next to a battery blinks, this means either the battery is not rechargeable or it is defective.
•
Remove the batteries from the charger and unplug the adapter from the power supply.
4. Charging times
(approximately – actual times may vary depending on brand and condition of the batteries):
size
charging current
capacity
time
1900mAh (order code
HR6/19
)
28 minutes
2000mAh (order code
HR6C/20
)
30 minutes
2200mAh (order code
HR6C/22
)
33 minutes
2300mAh (order code
HR6C/23B
) 35 minutes
AA
4A
2500mAh (order code
HR6C/25B
) 38 minutes
600mAh (order code
HR3
)
24 minutes
AAA
1.7A
750mAh (order code
HR3C
)
30 minutes
The information in this manual is subject to change without prior notice.