HAM1011
V. 03 – 15/03/2017
2
©Velleman nv
USER MANUAL
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of
the device after its lifecycle could harm the environment. Do not
dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, do
not install or use it and contact your dealer.
2.
General Guidelines
Refer to the Velleman
®
Service and Quality Warranty on the last pages of
this manual.
3.
Installation and Use
1.
Gently take the sensor body out of the support, or rotate it so the body
is square to the support.
2.
Open the battery lid by sliding it upwards, connect a 9V battery to the
connector and close the battery lid.
3.
Set the switch at the side of the sensor body to the desired operation
status:
o
OFF: the sensor is not operational.
o
CHIME: if the detector detects movement during over 10 seconds,
it will produce a short chime sound.
o
ALARM: if the detector detects movement during over 10 seconds,
it will sound an alarm.
4.
Fix the device with screws or double-sided tape, or use it standing
alone on a stable and level surface.
5.
When the battery is getting weaker, detection might take longer and
the sounds will not be as distinct. Replace it immediately when you are
aware this is the case.
