Velleman CAMSET33 Manual Download Page 1

CAMSET33  

GB 

1

CAMSET33  -  2-CHANNEL VIDEO SECURITY DOOR PHONE 

 

 

 

1. Introduction 

 
Thank you for buying the 

CAMSET33

. Read this manual carefully before bringing the device into service. 

This 

CAMSET33

 consists of one indoor unit with monitor and one outdoor unit with camera, with which you 

can see visitors and converse with them from inside your home, without having to open your entrance door. 
 

2. Generalities & Installation Tips 

 

1) Activation of units 

 

When the call button of the outside camera is pressed, the indoor unit's chime rings and the visitor’s 
picture appears on the indoor unit’s monitor. 
When you've visually identified the visitor, and you wish to converse with him/her, lift the handset and 
converse. The unit will remain activated for approximately 150 seconds before it automatically powers off. 

To re-activate for continued conversation push the “ON/OFF” button. 

 

2)  Activation of outside unit from inside unit 

 

Press the 'ON/OFF' button of the indoor unit at any time and the outdoor camera will be activated and 
show the outside view. 

 

3) Interphone 

 

When 2 or more monitors are installed, press the interphone button (6) to communicate with the other 
monitor(s). The amber LED lights up. 

 

4) Working time 

 
- Call time: approximately 30 seconds: the picture automatically disappears if the indoor unit is not 

answered within approximately 30 seconds after the call button of the outdoor unit is pressed. 

- Talk time: approximately 150 seconds: when the indoor unit is picked up, there is approximately 150 

seconds of time available before the units automatically shut down. 

- Monitor time : approximately 30 seconds: when outside camera is activated from inside, there is 

approximately 30 seconds of viewing time before unit automatically shuts down. 

 

5)  Door open function 

 
An electric DC door lock has to be purchased separately. The indoor unit can be wired to activate the 
door opener. 

 

6) Installation location 

 

Carefully select a site to install the outdoor unit, as it may be damaged by direct rainfall, strong vibrations 
or excessive dust. 
For optimum video display, the unit should be installed where direct sunlight cannot reach it. 
Inferior picture quality can also occur when the lens cover is scratched.  

Summary of Contents for CAMSET33







Reviews: