6 |
Page
4.INSTALLATION
When drilling into the vehicle body, make sure to check the other side and avoid drilling
into other components/wiring. Always apply sealant/paint to bare metal around the cut
surface to prevent rust.
Make sure to disconnect all power supplies to the vehicle including battery, generator, and
shore power prior to installation.
NOTICE
The installation procedure can be complicated. Please read the ENTIRE installation section
before starting to ensure the smoothest installation process. The general process should
follow the order below. Failure to do so can result time-consuming re-work.
1.
Identify unit location and exhaust vent location
2.
Drill holes for exhaust vents
3.
Install exhaust vents
4.
Identify drain hole location and drill the drain hole
5.
Pull out extension connector for the external control panel (optional)
6.
Secure the unit
7.
Connect exhaust ducts
8.
Connect drain hose
9.
Install air vent and connect duct (optional)
10.Install external control panel (optional)
11. Connect power
12. Test air flow