13 |
Page
4.3 Unit
NOTICE
The unit location needs to have proper airflow with the interior space. If the unit is installed
inside of a cabinet, a
5”x
5”
or similar size vent hole may need to be cut if insufficient air
flow is noticed during the test run section later.
•
Use the template to locate the install location.
•
Secure the unit with corner brackets: two on each side and one in the front and back.
If one side is against the wall, no brackets are needed for that side.
•
Refer to the drain hose section, install the L drain hose adapter in the preference
orientation (front or side).
•
Put the unit in place and use screws to secure the corner brackets to the floor. If the
screws tap into metal through to the exterior, apply sealant/ paint on the underside
at the protrusions.
•
Drill screws through the corner brackets into the side of the unit.
Do NOT over-
tighten
.