VMBKP
26
Velbus
–
Legen Heirweg 33, BE-9890 Gavere, Belgium
–
tel. +32 9 384 36 11
–
e-mail: [email protected]
–
www.velbus.eu
PN-VMBKP-ed1-A4
Duress codes (for user groups 1 & 2) (locations 41 & 42)
Duress Codes are for
Important Persons
in case of
DURESS
while they are operating the access control keypad. The
duress code operates like a normal User Code for User Groups 1 or 2, and at the same time activates the Duress Output
7
without any indication for the person(s) near the keypad. The user may use it to report an emergency and secretly ask
for help when they are forced to operate the keypad. For this to work, the Duress Output needs to be connected with a
security system (for example, an Auto-dialer).
NOTE: The Duress Codes are always valid. They are not subject to lockup.
Locations
Duress ID
Duress code
Validation
4 1 - 4 2
0 1
–
5 0
4-8 DIGITS
#
(1)
(2)
(3)
(4)
1.
Locations
•
4 1: Duress Code for User Group 1
•
4 2: Duress Code for User Group 2
2.
Duress IDs
•
0 1
–
5 0: 50 Duress IDs for User Group 1
•
0 1
–
1 0: 10 Duress IDs for User Group 2
•
0 9 9 9: Clear all the Duress Codes from the selected Location. Please see the Programming example below for
details.
3.
Duress Codes
•
50 Duress Codes can be programmed for User Group 1 and 10 for User Group 2. When a new Duress Code is
entered for an existing Duress ID, the old code is replaced.
•
Duress Codes can be 4-8 digits when Manual Mode
code entry is active (see “User code entry mode –
Auto or
manual (location 70)” on p.30).
•
When Auto Mode code entry is active, the Duress Codes MUST be the same digit length as the Master Code (see
“User code entry mode –
Auto or manual (location 70)” on p
.30).
•
The Duress Codes are 4-8 digits for Manual Mode code entry (see location 70).
•
Always set a Duress Code that is easy to remember in a panic situation. A variation of the daily used User Code
(e.g. one digit different) is highly recommended. For example: if the User Code is 1 3 6 9, then 3 3 6 9 or 1 3 6 0
might be a good choice for the Duress Code.
•
The Duress Code can also be used instead of the Secondary User Code or Common User Code after reading a
Card for the Duress reporting.
4.
Validation
•
Press the # key once. A double beep confirms the entry.
Examples
Example 1
Set a “Duress Code” with the number “3 3 6 9” for User Group 1
4 1
0 1
3 3 6 9
#
(1)
(2)
(3)
(5)
1.
Duress Code for User Group 1
2.
Duress ID
7
See “
” on p.
8 for more information
Summary of Contents for VMBKP
Page 1: ......