Veit SF26, Operating Instructions Manual

Page: 44 / 149

7.2 Operating state of the machine
7.2.1 Operating state
1. Machine in home position
n
All tensioning elements are open
n
Carriage in lower position
n
No automatic mode (pedal not pressed)
n
No finishing cycle active
2.
Machine in idle state
n
All tensioning elements are open
n
No automatic mode (pedal not pressed)
n
No finishing cycle active
7.2.2 Run to home position
Pressing the "stop" button when the machine is in idle state starts
the run to home position. The following sequence is started and
run through automatically.
n
All tensioning elements open
n
Fan off and steam valve closed
n
Carriage moves down until the lower reed switch is triggered
The machine is in home position.
7.2.3 Run to reference position
After the control system has been started, pressing the "reference
start" button starts the run to reference position. The following
sequence is started and run through automatically.
n
All tensioning elements open
n
Fan off and steam valve closed
n
The light barrier for hem detection is checked for validity.
n
The carriage moves up until the upper reed switch is triggered
and then down until the lower reed switch is triggered. After
successful completion of the reference run, the machine is in
home position and ready to operate.
Operation
Operating state of the machine > Run to reference position
18.07.2017 Shirt finisher VEIT SF26 44