Veit SF26, Operating Instructions Manual

Page: 41 / 149

6.3.4 Steam connection
The SF26 shirt finisher is connected to a water steam supply.
Machine working pressure 0.6 MPa (6 bar) at 158°C
Internal diameter of the steam
supply
1/2''
Steam must be connected according to the applicable technical
regulations.
The steam and condensate lines leading to the machine must be
provided with a stop valve. These stop valves must be installed
close to the machine so that the operating person may quickly dis-
connect the steam and condensate lines in the event of danger.
The steam and condensate lines must be laid such that there is no
risk of tripping over.
The water steam quality depends on the boiler water quality.
Boiler water requirements
Boiler water Must be colourless, clear, and
free from undissolved material
and foaming agents.
ph value (at 25°C) 9 - 12
Total hardness 5 dH, max.
Electric conductivity (at 25°C) 100 µs, min.
CAUTION!
Risk of burns
There is a risk of skin burns from hot water steam
under pressure.
Connection only by qualified person.
Do not touch any components that carry water
steam or condensate.
Service the dirt separator at the water steam outlet
and the condensate drain according to the mainte-
nance schedule.
Installation
Installation > Steam connection
18.07.2017 Shirt finisher VEIT SF26 41