Veit SF26, Operating Instructions Manual

Page: 33 / 149

6.2 Energy savings
The energy consumption of the machine can be
reduced when observing the following steps.
– Only switch on the machine when required.
– Switch off the machine during breaks or if it is
not used for a longer period.
– Use the standby function if it is available on the
machine.
– Only use the amount of steam and steaming
time that really is required for finishing the gar-
ment.
– Seal leaking hoses and fittings of the machine
(air, steam, condensate, water) and replace, if
necessary.
CAUTION!
Maintenance must only be carried out by an
authorised person.
Do not forget that the risk of injury is increased
during maintenance.
6.3 Installation
6.3.1 Power supply connection
Connect the SF26 shirt finisher to the power supply system.
The machine is provided with a connector. The connector must be
freely accessible and must not be blocked. Direct connection
without connector is not permissible.
Connection to the mains must be protected on site. The regulations
of the local distribution system operators (DSO) must be observed.
For the connection and protection on the line side, please refer to
the data in the circuit diagram or on the type plate.
The connecting cable must be laid in order not to contact hot
steam and condensate lines and such that operating persons
cannot trip over.
Installation
Installation > Power supply connection
18.07.2017 Shirt finisher VEIT SF26 33