51
6 Set up the sensor with the display and adjustment module
VEGAPULS 69 • Modbus and Levelmaster protocol
47252-EN-210205
•
Write into sensor:
Store data from the display and adjustment
module back into the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "
Setup
" and "
Display
"
•
The menu items "
Reset, Date/Time
" in the menu "
Additional
settings
"
•
The user-programmable linearization curve
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sen-
sors or kept as backup for a possible electronics exchange.
Note:
Before the data are saved in the sensor, a safety check is carried out
to determine if the data match the sensor. In the process the sensor
type of the source data as well as the target sensor are displayed. If
the data do not match, a fault message is outputted or the function is
blocked. The data are saved only after release.
In the menu item "
Scaling
" you define the scaling variable and the
scaling format for the indication of the level measured value for 0 %
and 100 % on the display, for example as volume in l.
In menu item "
Current output, variable
" you specify which measured
variable the current output refers to.
In menu item "
Current output, adjustment
" you can assign a respec-
tive measured value to the current output.
Additional settings - Scal-
ing
Additional settings - Cur-
rent output (size)
Additional settings - Cur-
rent output (adjustment)
