34
7 Setup
PLICSMOBILE • Mobile network unit PLICSMOBILE T81
55234-EN-191217
Caution:
The PLICSMOBILE T81 must be disconnected from voltage when
inserting the SIM card. Keep ESD protection in mind when handling
the SIM card. Electrostatic discharges can damage the SIM card or
the PLICSMOBILE.
SIM-Car
d
Fig. 17: Insert Mini-SIM card
To avoid misuse, the SIM card is generally locked by a PIN. To ensure
that PLICSMOBILE can contact these locked SIM cards, first of all
the PIN must be entered. For this purpose the assistant "
Activate SIM
card
" is available in the DTM. Enter here the correct PIN for the card.
The assistant also offers the option of changing the PIN.
Information:
When using the VEGA identification card, entering or deactivating a
PIN is not required.
Then check if the card is logged into the network and if sufficient net-
work coverage (signal strength) exists. For a reliable measured value
transmission, a signal strength of at least 15 % should be displayed.
This can be checked in the DTM menu "
Network information
" under
"
Setup - Diagnosis
". You can also see the general device status via
the status indication.
The following operating conditions are signalled via the yellow LED
(mobile network status indication):
•
LED does not light:
no operating voltage or power saving mode
active
•
Constant flashing:
Instrument is not logged into the GSM net-
work
•
Unsteady flashing (long OFF/short ON):
instrument is booked
into the GSM network
•
Continuous light:
Transmission or dial-up connection active
•
Quick steady flashing after continuous light:
Measured value
transmission failed
Activate SIM card
Status indication
