Vega LM-1 / User Manual
9
Revision 05
–
INITIAL STARTUP
Vega LM-1 tracking device is operating with the built-in battery, which you must
connect to the power connector on the board before starting. The Vega LM-1 6400 mAh has
a one battery which may be connected to any of two power connectors on the board. For
the Vega LM-1 12800 mAh you should to connect two batteries to the both connectors.
Vega LM-1 supports two activation methods in the LoRaWAN network - ABP and OTAA.
Select one of the methods using the
«
Vega LoRaWAN Configurator
»
application (see part 4).
1. ABP. After pressing the start button, the device immediately starts working in the
"Active" mode.
2. OTAA. After pressing the start button, the device makes three attempts to connect to
the network within the set frequency plan. After the activation in the LoRaWAN network is
confirmed, the device sends a signal (LED flashing for 3 seconds) and switches to the "Active"
mode. If all attempts fail, the device will continue to accumulate data and will attempt to
connect to the network every 6 hours.
Hold the start button pressed (min. 5 seconds) to switch the device from the "Active"
mode back to the "Storage" mode.
Power connectors
on the board