Vega DSP-223, Technical Manual

Page: 15 / 59

Tone Remote 11
4.2.2.8.5 Digital Output
Each function tone may be assigned a digital output. Valid entries are 0 – 64 that control the outputs
labeled DIG0-DIG5. This is a binary output corresponding to the value entered. The table below shows
the values and the resulting DIG0-DIG5 outputs.
An entry of 64 will cause the digital outputs to
REMAIN SET at the current value and not change.
VALUE D5 D4 D3 D2 D1 D0 VALUE D5 D4 D3 D2 D1 D0
0 L L L L L L 32 H L L L L L
1 L L L L L H 33 H L L L L H
2 L L L L H L 34 H L L L H L
3 L L L L H H 35 H L L L H H
4 L L L H L L 36 H L L H L L
5 L L L H L H 37 H L L H L H
6 L L L H H L 38 H L L H H L
7 L L L H H H 39 H L L H H H
8 L L H L L L 40 H L H L L L
9 L L H L L H 41 H L H L L H
10 L L H L H L 42 H L H L H L
11 L L H L H H 43 H L H L H H
12 L L H H L L 44 H L H H L L
13 L L H H L H 45 H L H H L H
14 L L H H H L 46 H L H H H L
15 L L H H H H 47 H L H H H H
16 L H L L L L 48 H H L L L L
17 L H L L L H 49 H H L L L H
18 L H L L H L 50 H H L L H L
19 L H L L H H 51 H H L L H H
20 L H L H L L 52 H H L H L L
21 L H L H L H 53 H H L H L H
22 L H L H H L 54 H H L H H L
23 L H L H H H 55 H H L H H H
24 L H H L L L 56 H H H L L L
25 L H H L L H 57 H H H L L H
26 L H H L H L 58 H H H L H L
27 L H H L H H 59 H H H L H H
28 L H H H L L 60 H H H H L L
29 L H H H L H 61 H H H H L H
30 L H H H H L 62 H H H H H L
31 L H H H H H 63 H H H H H H
64 No Change
Figure 6 Digital Output Chart
NOTE: Digital output bits D4 or D5 are not active if DIG4 or DIG5 are enabled
4.2.2.8.6 CTCSS Frequency and Default
This value allows the user to set the CTCSS frequency for a given function tone. When the function tone
is received, the CTCSS tone generator frequency is set to the value corresponding to the number
entered. An entry of 0 corresponds to no tone. If the
Use Default CTCSS checkbox to the right of the
CTCSS Frequency box is checked (see Figure 4), the value in the CTCSS tone box is ignored and the
last selected value is generated during PTT. For example, F1 is used for all transmissions and the
default CTCSS box is checked for F1. F2-F8 has different CTCSS values programmed for them without