Vega MT-5 CAN / User Manual
12
Revision № 04 of 01 July 2022
MOUNTING RECOMMENDATIONS
Before installing the block on an object, it is necessary to perform basic connection settings to be
able to connect to the block remotely via TCP. Connection settings are:
monitoring servers’ settings (protocol, IP-address and port);
network settings (SIM access point settings);
settings for transmitting readings (information that will be transmitted to the server).
Initial configuration is carried out through USB-port with Configurator application. For this you
should do the following steps:
1.
Install the main SIM-card (see part
2.
Connect the device to a PC through USB-port located on the front panel.
3.
Run the Configurator application on the PC, press “Connect” button and choose the connection
method like “Connect through USB”.
4.
On the left menu choose “Settings”.
5.
Make connection settings.
Pay attention to the settings for connecting to the engineering server using the
VEGA protocol. These parameters will be used when connecting to the device
remotely through the Configurator program
6.
After setting connection parameters press the “Save” button.
7.
Disconnect USB-cable.
8.
Try test connection through the air for checkup of the connection parameters.
9.
If the connection is successfully done, then the device is ready for installing on a vehicle.
For mounting you will need:
wires and fuse which are included in a package;
fuse;
wire stripper;
laptop.
