VeEX VePAL TX300M, User Manual

Page: 338 / 421

Multiple Streams - MAC/IP Address Setup
If all of the streams are going to the same far-end unit, then the MAC/IP destination addresses
must be the same on all of the streams.
If any of the traffic streams are going to more than one far-end unit then ensure the correct MAC/IP
destination addresses are configured for the respective streams.
Go back to top Go back to TOC
15.5.1.4 Traffic Settings (Per Stream Configuration)
In the Traffic tab the user is able to configure the traffic profile per stream, including frame size selection, traffic type, and
transmit rate.
Stream #:
Select a stream number to configure.
Traffic Flow:
Select from Constant, Ramp, Burst, or Single Burst traffic flow.
Frame Size (Type):
Fixed or Uniform. If uniform is chosen, the user will have to input a minimum and maximum frame
size.
Frame Size (bytes):
If a fixed frame size is chosen, this option is enabled. Enter the frame size when a Layer 2 or 3 is
selected. Frame sizes can be from 64bytes to 1518bytes, in addition to jumbo frames up to 10k bytes.
BW (Transmit Bandwidth):
Configure the transmit rate for the stream.
Note:
The bandwidth allocation per stream is already configured in the
General Settings
tab, but can be modified in this
screen as well.
For more information on Traffic Settings, please see 15.2.1.2 BERT Traffic Settings .
Throughput Setup - Traffic Setup - Constant Traffic Flow
TX300S_e-manual_D07-00-064P_RevA00