VeEX UX400, User Manual

Page: 90 / 209

Alarm injection can be performed during test. The type of alarms and alarm injection are configured in the Alarm Injection tab. Once the test is running, alarm injection can
be performed by pressing the
Alarm Inject
button on the right side of the screen.
Alarm Type:
Local Fault, Remote Fault, PCS-HI-BER, PCS-LOBL
Alarm Flow:
The alarm flow determines how the selected alarms will be injected. A specific Count or Continue (continuous) can be selected.
Alarm Length:
1s, 10s, or 100s.
Throughput Alarm Injection Setup
Go back to top Go back to TOC
6.5.1.6 Summary
The summary screen lists the MAC source and MAC destination information of each stream. Tap on the appropriate box of each tab to reconfigure the source or
destination information if desired.
Throughput Setup Summary MAC List
Go back to top Go back to TOC
6.5.1.7 Starting/Stopping a Throughput Test
Once all configurations have been made, tap the
Start
button on the right section of the screen to start the measurements.
Note: If testing on the fiber ports, make sure the LASER is turned On before starting the test.
The selected tests will run automatically. When all the tests are complete the test will stop automatically. If the RFC 2544 test suite needs to be stopped before they are
done, then simply tap the
Stop
button. The status of each selected test can be seen in the Results tab.
Go back to top Go back to TOC
6.5.2 Throughput Results
UX400 10G e-Manual D07-00-058P RevA00 Page 90 of 209