VeEX TX300s, User Manual

Page: 83 / 104

7.5.2.1 Setting Pass/Fail Limits
Whether measuring optical power or loss, there are always power input limits (saturation and Loss) or attenuation allowances that
determine whether the fiber cable meets the requirements for the desired application or network elements.
Power Limits (dBm): When check-box is ticked, users can enter the Minimum and Maximum power levels allowed for the
application (e.g. in line with the transceiver’s dynamic range). If the power reading falls beyond those limits, the power measurement
reading will turn red.
Loss Limits: Similar to power limits, user can set Minimum and Maximum amounts of optical power loss that are acceptable for the
application or specified for the cable or installation. User can simply specify the total amount of attenuation in dB. Alternatively user
can select the dB/km or dB/mi if the results are being compared against cable specifications. In this case, enter the length of the
cable under test for the test set to make the conversion.
Go back to TOC
7.5.3 WiFi Spectrum Analyzer
WiFi SA is a portable spectrum analyzer on a USB dongle that displays all RF activity in the WiFi bands (e.g.,s wireless networks,
cordless phones, microwave ovens, Bluetooth devices, etc.). It offers the following capabilities:
Helps determine the best available WLAN channels quickly for optimal performance
Helps to visualize and locate RF signals in the 2.4GHz and 5GHz spectrums
Discover and remedy competing access points
Optimize WLAN networks by locating and eliminating interference sources
WiFi SA Specifications
Supports 802.11a/b/g/n networks
Supports both 2.4 GHz and 5 GHz bands
Equipped with RP-SMA antenna jack
Allows user to replace standard external Omnidirectional antenna with a higher gain or directional antenna as
needed
The WiFi Analyzer is a compact and portable USB dongle that plugs into the USB 2.0 port of the V300 series
TX300s_Platform_Manual_RevB00 Page 83 of 104