VeEX RXT-6000e, User Manual

Page: 274 / 387

Go back to top Go back to TOC
13.5.1.5 Error Injection Settings (Per Stream Configuration) -
(Only in 10GE)
Error injection can be performed during test. The type of errors and error injection are configured in the Error
Injection tab. Once the test is running, error injection can be performed by pressing the
Error Inject
button on the
right side of the screen.
Stream #: Select the stream to configure.
Error type: Select from CRC, IP Checksum (Layer 3, 4 only), TCP/UDP Checksum (Layer 4 only), or Pause.
With Pause selected, the unit will transmit a pause frame when the
Error Injection
icon is pressed. The Pause
time duration is configurable in units of 512 bit time. At Gigabit Ethernet speed, this is equivalent to 512 ns. For
example, if pause time is set to 1000, the pause duration will be set to 1000x512 ns.
Injection Flow: The error injection flow determines how the selected errors will be injected. The user can select
a single error or a specific count.
Count: The user will be able to configure the error count via numeric keypad.
Throughput Test - Error Injection Settings per Stream
Go back to top Go back to TOC
13.5.1.6 Alarm Injection Settings
(Only in 10GE)
Alarm injection can be performed during test. The type of alarms and alarm injection are configured in the Alarm
Injection tab. Once the test is running, alarm injection can be performed by pressing the Alarm Inject button on the
right side of the screen.
Alarm Injection is available only with 10GE Port Tests.
Alarm Type:
Local Fault, Remote Fault
Alarm Flow: The alarm flow determines how the selected alarms will be injected. A specific Count or Continue
RXT-6200_RXT6000e_Module_Manual Page 274 of 387