VeEX RXT-6000e, User Manual

Page: 258 / 387

V-SAM - Setup - General (Page 1)
V-SAM - Setup - General (Page 2)
CIR Test Configuration
CIR Test Config.:
Select Simple Test, Step Load Test, or Simple and Step.
Simple Test: Starts the tests at the CIR.
Step Load Test: Starts the test below the CIR and continues in steps until it reaches the CIR.
Simple and Step Load Test: Step Load Test performs only if the Simple Validation test fails.
Tap on the
Test Duration
box to input a test duration (test duration must be less than 999 sec).
Tap on the table to modify the CIR value percentage for each step.
RXT-6200_RXT6000e_Module_Manual Page 258 of 387