VeEX RXT-6000e, User Manual

Page: 240 / 387

Throughput tab:
Max Rate: Up to 100% of the negotiated line rate. The default value is 100%.
This is the maximum transmit rate to perform the throughput test for each test frame size.
The user may configure this rate as a % of the total line rate or in Mbps. For example if the user
configures the Max Rate to be 90% and the negotiated line rate of the link is 100Mbps, then the maximum
transmit rate will be 90Mbps or 90% of the line rate.
Resolution: Input any value between 0.001% and 1%. The default value is 1%. Resolution refers to the
resolution in searching for the throughput rate. If 1% is selected, the throughput rate will be searched with ±1%
accuracy.
Duration: 5 to 999 seconds. The default value is 20 seconds.
The duration is the amount of time the throughput test is run for, for each frame size at a given rate.
RFC 2544 Setup - Throughput Settings
Go back to top Go back to TOC
Latency tab:
User configures the following:
Test: Throughput Rate or Custom Rate. The default value is throughput.
Throughput rate
: Latency test will be performed at the throughput rate found for each of the tested
frame sizes.
Custom rate: User configures a custom rate in % or Mbps.
Rate: Only available if Custom Rate is selected. Enter up to 100% of the negotiated line rate or enter the rate in
Mbps.
Duration: 5 to 999 seconds. The default value is 20 seconds.
This is the amount of time that the latency test will be performed for each test frame size.
Repetitions: 1 to 100. The default value is 1.
This is the amount of times that the latency test will be repeated for each test frame size.
RXT-6200_RXT6000e_Module_Manual Page 240 of 387