VeEX RXT-6000e, User Manual

Page: 194 / 387

Go back to top Go back to TOC
12.3.1.2 Interface
Tapping the Interface box opens the Interface Setup screen.
Interface Setup
Test Port: Optical interface is available for OTU-1e, OTU-2e signals.
Clock Source:
Can be configured as follows:
Internal clock: The clock for the transmitter is derived from the internal clock. The internal clock has an
accuracy of +/- 3.5ppm conforming to G.812 recommendations.
External clock: The clock for the transmitter is derived from
2Mbps (or 1.5Mbps) signal
2MHz (or 1.5MHz) BITS clock
64Kbps (co-directional) present on the SMA connector
2Mbps signal present on the RX2 balanced or RX2 BNC unbalanced
These options can be selected from them
Clock External
box.
Rx: The clock for the transmitter is derived from the received signal and the jitter of the incoming signal
is suppressed.
Offset: The clock for the transmitter is derived from the internal clock generator. It can change the offset
while measurements are running. Use the numeric key to increase and decrease the frequency shift, up to
0.01ppm. Frequency offset: ± 50ppm with 1, 0.1, 0.01ppm resolution.
Aux Line Code (1.5 Mbps, 2 Mbps only): HDB3, B8ZS, AMI
Go back to top Go back to TOC
12.3.1.3 Pattern
Tapping the Pattern box opens the Pattern Setup screen. The pattern setup will show when OTN Mapping is set to Test
Pattern.
RXT-6200_RXT6000e_Module_Manual Page 194 of 387