transmit rate. If the same traffic type applies to all streams, apply this profile to all streams using the Apply to ALL button
Frame Size:
Enter the frame size when a Layer 2 or Layer 3 BERT is selected. Frame size configuration is not available
for Layer 1 BERT. Frame sizes can be from 64bytes to 1518bytes, in addition to jumbo frames up to 9k bytes.
Traffic Flow:
Select from Constant, Ramp, or Burst traffic flow.
BW (Transmit Bandwidth):
Configure the transmit rate for the stream.
Note:
the bandwidth allocation per stream is already configured in the General Settings tab, but can be modified in this
screen as well.
Throughput - Traffic Setup Stream #1
Throughput - Traffic Setup Stream #2
7.3.1.5 Error Injection Settings (Individual Stream Configuration)
Error injection can be performed during test. The type of errors and error injection are configured in the Error Injection tab. Once
the test is running, error injection can be performed by pressing the Error Inject button on the right side of the screen.
Error type:
Select from CRC or IP Checksum (layer 3 only)
Injection Flow:
The error injection flow determines how the selected errors will be injected. The user can select a single
error or a specific count.
Count:
The user will be able to configure the error count via numeric keypad.
Throughput - Error Inject Setup Stream #1
Throughput - Error Inject Setup Stream #2
MX100/120 e-Manual D07-00-004 Rev A04
Page 58 of 115
