VeEX MPA, User Manual

Page: 497 / 842

Protocol Tabs
497
The Current column displays the most recent round trip measurement.
The Minimum column displays the fastest round trip measurement.
The Maximum column displays the slowest round trip measurement
•
Consecutive Good Time Required: This function allows you to enter the
duration (in milliseconds) of valid frames to occur before the round-trip delay
function is confirmed to be activated. It is used to fine-tune the measurement.
For all SONET and SDH processors the range is 0.125 to 2047.875 ms,
and is entered using a keypad.
•
Consecutive Good Frames Required: This function allows you to enter the
number of consecutive error-free frames to occur before round-trip
measurements stop accumulating. The range is 1 to 16383 frames and is
entered using a keypad.
SDH Test - SFP Info
The SONET, SDH and OTN protocol tabs on the MPM-10G module includes the
following SFP Info screen under the Test section.
The SFP Info screen displays common information from the pluggable SFP or SFP+
module’s 2-wire (I2C) interface, as programmed by the module's manufacturer.
The SFP Info screen can also be used to write to the SFP’s serial addresses as per the
SFF-8636 Specification.
The following 2-wire (I2C) Serial Addresses are compliant with SFF-8636
(Specification for Management Interface for Cabled Environments, Rev 2.7 January 26,
2016),
Table 6-15 Upper Page 00h Memory Map .
I2C Function Description Address Location
Module ID
Displays the module’s form-factor
Identifier code.
Example: SFP/SFP+
Page 00h Byte: 128
Size: 1 Byte
Ref. SFF-8024 Table 4-1
MPA_e_manual_D07-00-129P_RevA00