Introduction
National Electrical Code Compliance
8
National Electrical Code Compliance
The following information is for general reference and is not intended to replace recommended National Electric
Code (NEC) procedures. It is important for the installer to understand that electrical equipment and wiring located
in Class I, Division 1 and 2 installations shall comply with the latest appropriate articles found in the National
Electric Code (NFPA 70) and the Code for Motor Fuel Dispensing Facilities and Repair Garages (NFPA 30A), or
other local codes such as the CEC, Canadian Electrical Code.
AST tanks must be properly grounded according to NFPA 70 and applicable local codes and regulations.
MAG-XL FLEX PROBE WIRE LENGTH
Improper system operation could result in undetected potential environmental and health hazards if the MAG-XL
Flex Probe to TLS XL-Transmitter wire runs exceed 10 feet.
Veeder-Root Parts
• Veeder-Root MAG-XL Flex Probe, P/N 889111-XXX
• Veeder-Root Probe Components:
- 316 s.s. product float (2.05" dia., 0.54 sg, 350 psi), P/N
889001-001
- Weight Group (316 s.s. weight and 316 s.s. retaining pin)
• Veeder-Root MAG-XL Installation Kit (includes mounting hardware, transmitter and battery pack), P/N 858090-
202
• Optional 2-inch adapter/reducer (2” to 3/4”) kit (P/N 330020-666).
• Optional 4-inch riser cap and ring kit (P/N 330020-657).
Customer Supplied Parts
• Single-gang box from BELL outdoor, P/N 5321-0, or equivalent
• Single-gang blank cover from BELL outdoor, P/N 5173-0, or equivalent
• Galvanized threaded reducer bushing 3/4" to 1/2"
• Galvanized threaded 1/2” pipe, or 4” riser pipe, threaded to accept riser cap and ring
