5
System Setup
Daylight Savings Time
5-16
Daylight Savings Time
This feature allows you to enter Daylight Savings Start and End Dates/Times. Once enabled, the console will
automatically adjust for daylight savings time on the dates and times you enter here.
Press STEP to display the message:
To leave Daylight Savings Time disabled, press STEP. To enable Daylight Savings Time, press CHANGE, ENTER,
then STEP to display the Start Date message:
Press CHANGE then ENTER to select another start date. Press ENTER to accept your selected Start Date. The
Start Time message appears:
Press CHANGE then ENTER to select another Start Time. Press ENTER to accept your selected Start Time. The
End Date message appears:
Press CHANGE then ENTER to select another End Date. Press ENTER to accept your selected End Date. The
End Time message appears:
Press CHANGE then ENTER to select another End Time. Press ENTER to accept your selected End Time.
Re-direct Local Printout
This feature is available only if there is an RS-232 or DIM card installed in the console and Gilbarco protocol is
used.
Press STEP to display the message:
This option allows you to send a printout to Gilbarco’s printer instead of to the console’s printer. The default for
this feature is DISABLED. Press CHANGE, then ENTER to change the default to ENABLED. Accept the default if
you are not using Gilbarco protocol.
DAYLIGHT SAVINGS TIME
DISABLED
START DATE
APR WEEK 1 SUN
START TIME
TIME: 02:00 AM
END DATE
OCT WEEK 6 SUN
END TIME
TIME: 02:00 AM
RE-DIRECT LOCAL PRINTOUT
DISABLED
