19-1
19
Vapor Sensor Setup
The Vapor Sensor Setup function allows you to enter information about vapor sensors installed in vapor monitoring
wells at the site. You must enter data individually for each sensor. The information you enter tells the system the
number, location, and vapor thresholds of installed sensors.
Selecting the Vapor Sensor Setup Function
To select Vapor Sensor Setup, press FUNCTION until you see the message:
Press STEP to continue.
Vapor Sensor Configuration
If necessary, press STEP until you see the message:
Use this display to tell the system which sensor positions on a module are connected to vapor sensors.
NOTE: If vapor sensors are not installed, this function is not available.
HOW THE SYSTEM CONFIGURES VAPOR SENSORS
If vapor sensors are installed, the system recognizes the presence and module slot locations of Vapor Sensor
Interface Modules. The system also establishes a module number based on the slot location. For example, if
modules are installed in slots #3 and #6, the module in slot #3 automatically becomes module #1 and the module
in slot #6 becomes module #2.
As you specify which sensor positions on a module are connected to vapor sensors, the system establishes a
number for each sensor. For example, if there is a vapor sensor in positions 3 and 5 of module 1, the sensor in
position 3 becomes V3 and the sensor in position 5 becomes V5.
To indicate that a vapor sensor position is connected, choose the number corresponding to that position. For
example, if the position is 3, choose 3 for the position. To indicate that a position is not connected, choose X for
that position.
SPECIFYING VAPOR SENSOR POSITIONS
To specify whether the first position is connected, press CHANGE until the correct choice appears (1 if the
position is connected, X if it is not). Press the Right Arrow key to move to position 2 and press CHANGE again
until the correct choice appears. Repeat these steps until you have correctly specified all sensor positions. When
you have entered a choice for all positions, press ENTER to confirm your entry. The system displays the following
message:
VAPOR SENSOR SETUP
PRESS <STEP> TO CONTINUE
SENSOR CONFIG - MODULE 1
SLOT # - X X X X X
SLOT # - X X X X X
PRESS <STEP> TO CONTINUE
