18
Liquid Sensor Setup
Liquid Sensor Location
18-2
Press STEP. If more than one module is installed, the system automatically advances to the SENSOR CONFIG
message for the next module. Up to 8 modules may be installed. Repeat the steps described above for each
module until you have entered the configuration information (sensor positions) for all modules and the system
displays the ENTER SENSOR LOCATION message.
Liquid Sensor Location
If necessary, press STEP until you see the message:
To enter the location of a liquid sensor, press TANK/SENSOR repeatedly until the sensor you want appears on
the second line of the message (L1, L2, L3, etc.). Press CHANGE and enter the location (up to 20 alphanumeric
characters) of the selected sensor. Typical entries would be: INTERSTITIAL TANK 1; SUMP TANK 1, etc. (This
information will appear on sensor status and sensor alarm reports to make it easier to identify the location of
alarms.) Press ENTER to confirm your entry:
Press STEP to continue.
Liquid Sensor Type
If necessary, press STEP until you see the message:
If necessary press CHANGE to display additional liquid sensor types (see table below):
Sensor Type Entry
Applicable V-R Sensor
V-R Part Number
Tri-State (Single Float)
Sump sensor
794380-208
Steel Tank sensor
794390-420, 794390-460, 794380-333
Fiberglass Interstitial Float sensor
794390-401, -404, -407, -409
Position-Sensitive sensor
794380-323
Steel Tank sensor - Stainless Steel
794380-430
Mini-Hydrostatic, Single Point sensor
794380-304
Normally Closed
None
None
Dual Float Hydrostatic
Dual Point Hydrostatic sensor
794380-302 (soon to superseded by 794380-303)
Dual Float Discriminating*
Discriminating Pan sensor
794380-322
Discriminating Sump sensor
794380-352
Dual Float High Vapor
Discriminating Pan sensor
794380-322
Discriminating Sump sensor
794380-352
Interceptor (European - limited to
certain specific Interceptor types)
Interceptor sensor
720-000-1000
*For Oil/Water Separator sensors (P/N 794690-XXX) use Dual Float Discriminating for sensor type.
ENTER SENSOR LOCATION
L1:
L1: (Sensor Location)
PRESS <STEP> TO CONTINUE
L1: ENTER SENSOR TYPE
TRI-STATE (SINGLE FLOAT)
