TCP/IP Module IP Address/Configuration Using Telnet
Entering the TCP/IP Interface Module’s IP Address
19
Table 4. Telnet Setup Menu Settings (Consoles with V15 - 20 Software)
Menu Selection
Setting
BASIC PARAMETERS - to access, select Change Setup option 0, press Enter
IP Address (of console)
(get from your network administrator)
Gateway
(get from your network administrator)
Netmask’s number of bits
for host part
(get from your network administrator, or get from Table 5)
Telnet config password
(N)
CHANNEL 1 - to access, select Change Setup option 1, press Enter
Baud rate
9600
I/F Mode
4C
Flow
00
Port
10001
Connect Mode
C4 (incoming net connection - accept unconditional; startup - manual connection)
Remote IP Adr
IP address of the computer the console will call on dialout. Example: 010.002.001.059
1
(Remote) port
port of the remote computer
Disconn Mode
80 (with DTR drop)
Flush Mode
00
Disconn Time (mm:ss)
01:30 (Note: to enter Disconn time, first enter minutes press Enter, then enter seconds and press Enter)
Sendchar1
00
Sendchar2
00
1
When setting up the console to dial out, enter CXXX for receiver phone number - where xxx is the last set of digits in the Remote IP
Address set in Channel 1 of the Telnet Setup menu. For example, if you have a remote IP address of 010.002.001.059, you would enter
C059
.
SECURITY - to access, select Change Setup option 6, press Enter
Telnet setup is
enabled
TFTP download is
enabled
Port 77FEh is
enabled
Web Server is
enabled
Enhanced password is
disabled
SAVE AND EXIT - after making the above selections, select Change Setup option 9, press Enter
