3
Installation
Mounting The Insite360 Connect
The Insite360 Connect must be installed within 7 feet of, and in the same area and environment as, your ATG.
The Insite360 Connect requires access to a 100 to 240Vac wall outlet for its power supply. Mount the
Insite360 Connect using either the provided screws (Method A) or the hook and loop self-fastening strips
(Method B).
Method A
Method B
1. Cut out template (inside back cover of this manual)
2. Drill 2 pilot holes
4. Push slots in back of the unit onto
mounting screws (1) and slide down (2)
3. Install wall anchors
1
2
2. Remove the
paper cover from
the adhesive side
of one of the self-
fastening strips
and press it onto
the cleaned wall
surface.
1. Open one alcohol
packet from the kit
and clean the back of
the Insite 360
Connect and the wall
surface where you
want to attach the
unit.
3. Remove the paper cover from
the adhesive side of the other
self-fastening strip and press it
onto the cleaned back of the unit.
4. Ater waiting 20- 30 minutes
for the self-fastening strips to
bond to their surfaces, align the
Insite360 Connect strip over the
wall strip and push the unit
firmly against the wall.
