EMR
3
Setup and Operation Manual
C&C Mode Setup Categories
35
Figure 39. Input Type Setup
Product Description
Figure 40 illustrates Product Description setup choices. You can assign up to eight products for the EMR
3
. Each
product has a type, a name, and if the Temperature Compensation option is installed, a temperature compensation
factor. The availability of temperature compensation is a factory installed option of the EMR
3
. Thermal
compensation for all products is calculated by either thermal coefficient or density, which you select in Delivery
Options Setup (page 43).
Entering a Custom Name for a Product Type
There are eight default Product Types in the EMR
3
. If you select one of the default Product Types you do not have
to accept a default Product Name. For example, if you wanted to assign Jet Fuel to Product 1, select Kerosene as
the Product Type for Product 1 and change the Product Name from Kerosene to Jet Fuel.
Press ENTER
to return to
FUEL SOURCE
ENTER
INPUT TYPE
NEXT
QUADRATURE
CUR LOOP LOCAL
SINGLE PULSE
DUAL PULSE
SWITCH CLOSURE
RS-485 LOCAL
-
+
Press ENTER to
accept choice and
return to
INPUT TYPE.
ENTER
CW COUNT UP
CCW COUNT UP
-
+
NEXT
Note: If after setting count direction, the Register
Field displays a negative dispense volume, you will
have to reset this entry to the opposite direction.
Quadrature is the default.
Note: Select Quadrature for the standard
Veeder-Root Pulse Generator.
The Quadrature input type is the only input
type available in this version of software.
