21
DIS-51 Configuration Screens
Sub-Menu Information
Sub-Menu Information
Configuration, sub-menu information:
Configuration, sub-menu information -> firmware version:
Configuration, sub-menu information -> serial number:
Entering and Changing the Security Code in DIS-51
If you enable Serial Command Security in the console you must also enable it in the
DIS-51, and the security code must be set to the same code in both the console
and the DIS-51.
1.
Long press the push-button switch until you enter Configuration Main menu.
Short press the push-button switch until you are at the “security code” option,”
then long press to select it.
Summary of Contents for DIS-51
