TappingMode AFM
Basic TappingMode AFM Operation
Rev. D
Dimension 3100 Manual
139
9.2.8 Show All Items
Before changing any parameters, you should display all of the available parameters. If you cannot
view a parameter in a panel, you might need to enable this parameter.
1. Click the “minus box”
in the upper left corner of the panel, and click
Show all items
.
Figure 9.2d
Select Show All Items
2. Ensure there is a “
X
” in the check box to the left of all parameters.
Note:
Those parameters without a
X
will not display in normal Realtime mode.
Figure 9.2e
Enable Parameters
3. Click the “minus box”
in the upper left corner of the panel, and click
Show all items
.
The panel will once again appear in normal Realtime mode.
a.Click here
b.Select this
045
With “
X
”
Parameter
will display
Without “
X
”
Parameter will
not display
044
Summary of Contents for Dimension 3100
