Veeco Dektak 150, User Manual

Page: 33 / 349

2-6 Installing the Dektak 150 System
•
Box 2: Surface profiler main unit.
•
Box 3 : Installation tool kit, universal power strip, optical assembly, power cords, USB cable,
serial cable, stage, calibration standard(s), styli, and stylus shield.
•
Box 4 : Environmental enclosure.
•
Box 5 : Optional video monitor and cables.
•
Box 6 : Optional vibration isolation table or platform.
Unpacking Guidelines
As you unpack the other boxes, bear in mind:
•
The complete shipping list for your system is included in Box 1. Verify the contents of the
complete set of boxes against that list.
•
As you unpack the boxes, collect the following items and store them in a safe place:
•
Extra stylus tips
•
Stylus exchange tool
•
Calibration standard(s)
•
Veeco software
•
Operating system software
•
In case the system must be transported, save all boxes and packing materials until acceptance.
•
After acceptance, save Box 2 to safely ship the profiler should that prove necessary.
Unpacking the Surface Profiler
1 Move Box 2 as close as possible to the work surface on which the profiler will sit.
2 Open the top of the box, and remove the top foam and middle foam inserts.
3 The system is shipped in a plastic bag. Open the top of the bag and push it down to expose the profiler.
4 With at least two people, lift the profiler by placing your hands under its base at either end of the casting
(see
Figure 2-4
). Do not lift from the top of the system.
WARNING: Attempting to lift the system without assistance may result in personal
injury and/or damage to the equipment.
AVERTISSEMENT: Soulever le système sans assistance pourrait entrainer des blessures
et/ou endommager les équipements.
WARNUNG: Der Versuch, das Gerät ohne Hilfe zu heben, könnte zu körperlicher
Verletzung und/ oder Beschädigung des Gerätes führen.