Vectronic Aerospace VERTEX Lite Collar, User Manual, Page: 70 / 87

Changing of battery pack 70
© 2017 VECTRONIC Aerospace GmbH
Figure 54: Removing the battery connector from oval collar
Unscrew the two nuts and remove the washer on the non-adjustable side of the collar
with the battery connector.
Carefully pull the battery connector from the battery pack
(Figure above, left). The battery pin socket is located between the two screws (Figure
above, centre).
To attach a new battery pack, replace the O-ring on the battery plug and
carefully push
the three threaded pins of the connector plug into the connector socket (Figure above,
right). Be careful to avoid any damage to the connector! Place the washer on the
threaded pins and reattach the collar with new self-locking nuts to ensure that the O-ring
of the nuts is not damaged.
NOTE: After you changed the battery pack of your collar, a GPS coldstart is necessary.
For this please refer to GPS Monitor.
11.2 Round Collar, standard battery pack
Figure 55: Battery connector on round collar, standard battery pack
Remove the screws attaching the bracket to the battery pack with an 8 or 7 mm
(depending on collar size) hexagon socket wrench (delivered with the collar). Start with
the screws on the adjustable side and then remove the screws attaching the battery
connector.