VDO OCEANLINK -, Operating Instruction

Page: 68 / 204

68
Configure and calibrate the fuel level sensor
1. Press the MENU button and select SENSOR
CONFIG .
2. Use Engine 1 connector or Engine 2
connector to select the connector to which the
sensor is connected.
3. Select the input connected to the sensor (i.e.
Resistive pin 8 ): "Off" appears to indicate that
no sensor is linked to the input or was disabled.
4. Select Fuel : Show value as and Calibration
parameters appear.
5. Select Show value as , then select the ID to be
assigned to the tank connected to the sensor.
6. Select Calibration to open calibration options.
7. Select Tank volume , to set tank capacity.
8. Select Sensor type , then select the sensor
type.
9. Select Calibration , then select the one or
three point calibration procedure ( Do 1 point
cal / Do 3 point cal ): calibration instructions
and the ohm value read in real-time by the
sensor
[A] appear.
10. Empty the tank and wait for the read value to
stabilize. Then confirm by pressing ENTER .
11. For three point calibration, follow the on-screen
instructions.
12. Hold down the MENU button to return to the
data pages.
Sensor configuration
7” TFT display | Operating instruction v. 1.0 | © 2018 Continental Automotive Switzerland AG