For your safety
Notes on operation
4
• Edition 01/2
009
Notes on operation
Designated use
The Roller Interface Module is a CTC II component. It is used for the
inspection, commissioning, and programming of radio slot sized tachographs
(EC recording equipment and Non-EC tachographs) on a test stand. The
Roller Interface Module may only be used for the purpose for which it was
manufactured. The manufacturer is not liable for any damage caused by
improper use.
Moisture and
dampness
Prevent moisture or dampness from seeping into the module. The Roller
Interface Module may not be operated in the proximity of water. Do not place
any liquid container (like a tumbler, etc.) on or beside the module – this will
avoid any spillage getting into the device.
Environmental
requirements
Protect the Roller Interface Module from heat and cold. Do not place the Roller
Interface Module near heat sources (e. g. blowers, ovens, etc).
Do not place the test device in direct sunlight.
The ideal environmental temperature is 25 °C.
Operating instructions
Avoid excessive jolting and shaking of the module.
Cleanliness
Prevent dust and dirt from getting into the module.