Firewire Connector
Mouse (above) and Keyboard (below)
Connectors
LAN/Ethernet ( above) and USB (below)
Connectors
VGA Connector
Parallel Port Connector
Digital Monitor Connector
Video Output
Line Out
Line In
Microphone
Serial Port.
Power
The Elite Series unit should be plugged into a UPS (Uninterrupted Power Supply).
A
TTENTION
The correct voltage should be selected on the Voltage
Selection Switch
before plugging the
power cord of the Elite Series unit into a three-pin plug in outlet.
Monitor
The Elite Series may be connected to a standard analog computer monitor via the
VGA
connector, a digital monitor via the
Digital Monitor
connector or to a standard security
television using composite output via
Video Output
.
Make sure that the monitor is also
connected to an adequate power supply receptacle – preferably it should also be connected to
the UPS.
Real Time Monitor
Additionally, the Elite Series has an extra output (
Video Output Connector
) for a real-time
video monitor. The connector for this output is located next to the
Video Input
Connectors
.
Keyboard/Mouse
Connect the keyboard and mouse to the
Keyboard
and
Mouse
connectors on the rear
panel of the Elite Series unit.
Cameras
The cameras should now be connected to the
BNC connectors
on the rear of the Elite
Series unit.
The camera positions are clearly marked next to each connector. Depending on the model
being used, there are four or sixteen inputs to the Elite Series unit. If you are using less than
the maximum number of cameras, it is preferable to connect them starting at position 1 and
working up consecutively to the last camera position.
Elite Series – Secure Access Video Surveillance
User Guide and Installation Manual
Page 12 of 48 Pages
