VCS VideoJet 1000, Manual, Page: 21 / 106

Installation
23
VideoJet 1000
Connections
Camera Any standard video source (CCTV camera) can be connected to
the VideoJet 1000. All cameras and any video source which deli-
vers a standard PAL or NTSC signal are suitable.
)
Connect the camera or other video source using video cable
(75 Ohm, BNC connector) to the BNC socket
Video In .
Monitor The VideoJet 1000 has an analog monitor output for connection to
a suitable PAL or NTSC monitor when the unit is to be used as a
receiver.
)
Connect the video monitor using video cable (75 Ohm, BNC con-
nector) to the BNC socket
Video Out .
Network The VideoJet 1000 can be connected to a 10/100 Base-T network
either directly or via a hub. For this purpose use standard UTP
Cat 5 cable with RJ45 connectors.
)
Connect the network cable to the socket Ethernet.
Alarm input The alarm input is provided for switching an external alarm gener-
ator, e.g. a door contact or sensor. Using the appropriate configura-
tion an alarm generator, for example, can activate the automatic
connection setup between the VideoJet 1000 and a remote loca-
tion.
A voltage free closing contact or switch can be used as activator.
Note
Where possible, a switch with minimum contact bounce should be
used as activator.