vc999 TR2, Translation Of The Original Operating Instructions, Page: 77 / 99

Dryer VC999 TR2
Maintenance
29.11.2013
77/99 Art. No. 594.301
11.3.1.1 Adjust belt tension on blower
11.3.1.2 Replace belts in blower
Proceed exactly as described in Chapter "11.2.2 Check belt tension on blower". In instruction step
3, however, the tension on the belts must be loosened enough that it can be pulled over the drive
wheels.
Procedure
1. Prerequisite: Remove right machine cladding
(Fig. 3/1, Item 16) and protective covering on
blower as described in Chapter "11.2.2 Check
belt tension on blower".
2. Loosen the 4 screws (1) of the motor fastening
plate. Use a 17mm screw-wrench for this.
3. Loosen the nuts (2) and set the belt tension using
the nut (3) (19mm screw-wrench). Only tighten
the screws lightly (1).
4. Check the belt tension as described in Chapter
"11.2.2 Check belt tension on blower".
5. If the belt tension is correct, then retighten the nut
(2) and then the 4 screws (1). If not, readjust.
6. Re-mount the protecting covering and right
machine cladding.
Fig. 11/10
1
2 3