PO-1581
10
CHARGING YOUR E-SCOOTER / INSPECTION, MAINTENANCE AND STORAGE
CHARGING YOUR E-SCOOTER
Rubber plug
Plug in
After charging,
fasten the rubber plug
Step 1:
Ensure that the charging port is clean and dry.
Step 2:
Plug the charger into the power outlet, then connect the cable with the power supply (90 ~ 240V; 50,60 Hz),
make sure the light on the charger is lit GREEN.
Step 3:
Connect the charging cable into the charging port of the E-Scooter. The indicator light on the charger should
change to RED, indicating that your E-Scooter is now being charged. When the red indicator light on the charger turns
to GREEN, your E-Scooter is fully charged. A full charge typically occurs within 3 hours. The charger will automatically
stop charging when the light is GREEN.
Step 4:
Please unplug the charger from the E-Scooter and from the power outlet.
NOTE:
If the GREEN light on the charger does not turn RED when you plug it into your E-Scooter, check that all the
connections are properly connected or that the E-Scooter is not already fully charged.
INSPECTION, MAINTENANCE AND STORAGE
Your E-Scooter requires routine inspection and maintenance. This chapter describes maintenance steps and important
operating tips. Before you perform the following operations, ensure the power and charging cable is disconnected.
INSPECTING YOUR E-SCOOTER
Before you ride the E-Scooter; check that the front wheel is properly aligned and connected to the handlebars. Position
the front wheel between your feet and gently move the handle bar from side to side to check wheels follows the
handle bars. If any problems, contact after sales support.
Routinely check the body of the E-Scooter and tyres for damage or excessive wear, check all bolts and screws and
tighten them if needed.
CLEANING YOUR E-SCOOTER
Disconnect the charger and turn off your E-Scooter.
Avoid using water or other liquids and cleaners on the E-Scooter while cleaning. Wet a clean cloth with clean soapy
water, wring out the cloth thoroughly, and wipe the body of the E-Scooter, making sure that water does not get into
the power button, charging port, the foot mats, locking mechanism or tyres.
STORING YOUR E-SCOOTER
Fully charge your battery before storing.
Summary of Contents for PO-1581
Page 1: ...USER GUIDE PO 1581 E SCOOTER...
Page 2: ...Danish manual can be found at www envivo nu dk...
Page 12: ......
