Headless
Screw (D)
150901
Page 1 / 4
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
T0181 / T0182 / T0183 / T0184
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
BulbType A Max.100W
(not included)
Take T0181 as an example, T0182,T0183,
T0184 follow below installation step.
Features
1. Energy saving fixture.
2. Use the dim-to-bright illumination option where
you want some minimum illumination through out
the night, such as at your front entrance or
garage door. Use the dark-to-bright illumination
option where you do not need minimum
brightness, such as the backyard or back porch.
3. When in manual override mode, use wall switch
to keep the light ON till dawn.
Important to Know
1. Read all instructions carefully before installation and
operation.
2. If you are not familiar with state and local electrical codes,
it is recommended that you consult with a qualified
electrician.
3. Before installation, shut off power at the main fuse or
circuit breaker box. Be aware that simply turning off the
wall switch is not sufficient to prevent an electrical shock.
4. This fixture requires a 120V AC, 60 Hz power source.
5. Do not attempt to take the lantern apart; there are no
serviceable parts inside.
6. To avoid sensor damage by lightning or electrical surge,
make sure the grounding wire is securely connected.
7. For general safety and to avoid any possible damage to
the sensor, be sure the power is switched "off" before
replacing the bulb.
Maximum Wattage: 100W Incandescent bulb
Work Temperature: -4ºF ~ 104ºF
House Grounding Wire
Green Grounding Screw (C)
Wire Nut (E)
Mounting Screw (B)
Headless Screw (D)
Outlet Box
Fixture Wire
Lock Nut (F)
Back Plate
Rubber pad(G)
Fixture
Ball Nut(H)
Mounting Plate (A)
Fixture Grounding Wire
Hardware Package (included)
：
Mounting
Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Rubber Pad (G)
Mounting Plate (A)
Ball Nut (H)
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
T
1. Thread two headless screws through the mounting plate, and then secure them with four lock nuts (two on each
side of the mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally in order to make the fixture level.
Installation Steps
Turn off the power at fuse or circuit box.
