ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0130 / T0134
Back Plate
Ball Nut (G)
Bulb Type A Max.60W
(not included)
Rubber Pad (H)
Parts:
141029
Mounting Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Cross Bar (A)
Ball Nut (G)
Frame
Headless Screw (D)
Rubber Pad (H)
Photocell
Rubber Pad
Fixture
Finial
Glass Panel
Cross Bar (A)
House Grounding Wire
Green Grounding Screw (C)
Fixture Grounding Wire
Wire Nut (E)
Outlet Box
Fixture Wire
Mounting Screw (B)
Lock Nut (F)
Headless Screw (D)
IMPORTANT:
The sensor has an excellent photocell function to
enable the light to turn on at dusk and off at dawn
automaticlly.
Turn off the power at the main fuse or circuit breaker box.
1. Thread two headless screws through the cross bar, then secure them with four lock nuts ( two on each side of the
cross bar). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be level.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Installation Steps
